3.2.7
Adjustment of Distance Between Documents in the 2-in-1 Mode
Requirement
The second document should be 0 to 1 mm in the direction of b from the trailing
edge of the first document.
1. Set "U-4" (Lightweight Original) of User's Choice to "1." (Make the adjustment
in the Lightweight Original mode.)
NOTE: Metric areas only
2. Slide the Document Positioning Plate towards the rear and secure it with tape.
3. Affix a piece of tape to each of the Magnet Catch Plates.
4. Place two A4Y documents on the Document Feed Table, and select
1-sided original/1-sided 2-in-1 copy mode.
5. Press the Start key, then press the Stop key immediately.
6. Open the ADF gently and check whether the 2nd document is positioned
correctly in relation with the 1st document.
7. Set the service choice mode "c-34".
8. Referring to page D-17, adjust the document stop position.
AFR-12/AF-5
NOTE
a
b
D-14
Rev. 1.0/05.99