Konica Minolta AFR-12 General, Mechanical/Electrical page 48

3.1.5 Removal of the Document Take-Up Unit Assy
Remove the Transport Belt.
Remove the Maintenance Cover and unplug the connectors from PWB-A as
shown in the figure. Remove the Single Feed Tray.
Remove the ADF from the copier, and place it on a table upside down.
Remove the Cover.
Remove five screws, open the Feed Cover and lift out the Document Take-
Up Unit Assy.
When reinstalling the Document Take-Up Unit Assy, make sure that the Feed
Cover is open. Tighten the five screws lightly by hand, then tighten securely after
the ADF is reinstalled on the copier.
Rev. 1.0/05.99
NOTE
D-5 AFR-12/AF-5