3.2.10
Adjustment of Document Stopper Solenoid SOL1
1. Remove the Document Take-Up Unit Assy and place it on a table upside down.
2. Loosen two screws and bring the brush (marked "A" in the figure) of the
Document Stopper Guide Plate into contact with the Take-Up Roller.
3. While pressing the Document Stopper Guide Plate against the Take-Up Roller
gently, lift the solenoid by holding the two screws until it comes to a stop, then
tighten the screws.
After completion of adjustment, lift the Document Stopper Guide Plate to check that
the Guide Plate is supported smoothly by the retaining force of the solenoid.
Rev. 1.0/05.99
NOTE
D-17
AFR-12/AF-5