Konica Minolta AFR-12 General, Mechanical/Electrical page 51

3.2 Adjustments
3.2.1 Adjustment of Magnet Height
Requirement
The clearance between the Magnetic Catch and Original Glass should be
0 to 0.5 mm.
1. Remove the Transport Belt and two Screw Covers. (Push up from inside)
2. Set the Transport Belt and, close the ADF, loosen the Magnetic Catch adjusting
screws, check the clearance of the Magnet Catch, then tighten the adjusting
screws.
AFR-12/AF-5
NOTE
D-8 Rev. 1.0/05.99