Konica Minolta AFR-12 General, Mechanical/Electrical page 33

(1) Flow of Paper Passage Test
Load a required number of sheets of paper on the Single
feed Tray, then turn PSW1 ON.
Turning PSW1 ON during a test will interrupt the test.
Turning it ON again will eject all the sheets of paper and
terminate the test.
In the case of the intermittent mode, the test is carried
out each time the PSW1 is turned ON.
(2) LED Status when the Copier is in Standby for Paper Passage Test
Faulty sections are indicated as follows while the copier is in standby for a
paper passage test. If no fault is present, all the LEDs (LED1 to 4) will be
OFF.
LED
1 2
LED5 blinks at all times.
Rev. 1.0/05.99
Select the desired test mode.
The selected test mode starts.
3 4 5
: For monotoring
NOTE
S-3
Discription
Take-up cover set is faulty.
ADF set is faulty.
Turnover (AFR-12) cover set is faulty.
: Not lit : Lit up
AFR-12/AF-5