Hardware Hookup - Crestron Isys TPMC-12L Operation Manual

Crestron TPMC-12L
Ventilation
Connect the Device
Hardware Connections for the TPMC-12L
Ground
NET:
To Control System and
Other Cresnet Devices
Operations Guide – DOC. 6686C

Hardware Hookup

The TPMC-12L should be used in a well-ventilated area. The venting holes should
not be obstructed under any circumstances. If the TPMC-12L is hot to the touch,
consider used forced air ventilation.
To prevent overheating, do not operate this product in an area that exceeds the
environmental temperature range listed in the table of specifications. Consideration
must be given if installed in a closed or multi-unit rack assembly since the operating
ambient temperature of the environment may be greater than the room ambient
temperature. Contact with thermal insulating materials should be avoided on all sides
of the unit.
Make the necessary connections as called out in the illustration that follows this
paragraph. Refer to "Network Wiring", "CAT5 Wiring" and "QuickMedia Wiring"
on page 13 before applying power. If the TPMC-CH-IMC is to be used for
connecting CAT5 audio and CAT5 video, refer to the latest revision of the
TPMC-CH-IMC Operations Guide (Doc. 6345) for more information.
MEMORY
EXPANSION:
For MMC
Compatible Card
USB:
For 3rd Party
Peripherals
CAUTION: Do not apply excessive pressure to the touch screen display during
handling. Doing so can crack the screen and damage the touch screen.
CAUTION: Use only the TPMC-CH-IMC Interface Module when connecting to
the VID IN port. Use of the older "IMC" products, such as those with a 10-pin RJ-45
based interface, could damage the touch screen.
NOTE: Ensure the unit is properly grounded by connecting the chassis ground lug
to an earth ground (building steel).
®
Isys 12" Wall Mount Touch Screen
QM IN:
QuickMedia Audio,
Video & Mic
Input Over CAT5
LAN:
10/100/1000 Mbps
High Speed Ethernet
®
12" Wall Mount Touch Screen: TPMC-12L • 41
Isys
AUD I/O:
Balanced Audio In
& Mic Out Over CAT5
VID IN:
Balanced Video
Input Over CAT5