Table of Contents
Advertisement
Total Access 1240 Installation and Maintenance Practice
SHDSL Loop 1 Alarm Thresholds Menu
The SHDSL Loop 1 Alarm Thresholds menu (see
the thresholds for each interval. When set, each threshold dictates the level or number of
alarm counts at which an SNMP trap is sent.
'N' - Next Loop
Figure 5-59. SHDSL Loop 1 Alarm Thresholds Menu
The SHDSL Loop 1 Alarm Thresholds menu options are described in
Table 5-56. SHDSL Loop 1 Alarm Threshold Menu Options
Option
Alarm Threshold
1
SNR Margin
2
Loop Attenuation
3
ES 15 Minute
5-78
Figure
Total Access 1240
SHDSL Loop 1 Alarm Thresholds
1.
SNR Margin
2.
Loop Attenuation : Disabled
3.
ES 15 Minute
4.
SES 15 Minute
5.
UAS 15 Minute
6.
LOSWS 15 Minute
7.
CVC 15 Minute
Selection:
'P' - Prev Loop
'S' - Select Loop
Description
This field is used to enable or disable the Signal to Noise
Ratio Margin.
The SNR Margin sets a threshold from 0 to 15 dB, which
is used to determine alarm status.
The parameters for SNR Margin are 1 to 15 dB.
This option is used to enable or disable the Loop
Attenuation setting.
Loop Attenuation is used to set a loop loss value from 1
to 27 dB, which determines alarm status.
The parameters for Loop Attenuation are 1 to 127 dB.
This option is used to enable or disable the Errored
Second setting.
ES is a count of 1-second intervals during which one or
more Cyclical Redundancy Check (CRC) anomalies are
declared and/or one or more LOSW defects are declared.
The parameters for ES are 1 to 900 seconds.
5-59) is used to enable, disable, or set
09/01/05
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
'?' - System Help
Table
03:10
5-56.
61179605L5-5B
Advertisement
Table of Contents
