Table of Contents
Advertisement
1
Preparing the Mower
No Parts Required
Procedure
Perform the following procedure to prepare the mower
for attaching the blower and finishing kit.
1.
Disengage the PTO, move the motion-control
levers to the N
EUTRAL
engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Pull the spark plug wires.
4.
Repair all bent or damaged areas of mower
deck and replace any missing parts.
5.
Clean the mower of any debris on the deck or
rear part of the mower to ease installation.
-
position and
LOCKED
2
Installing the Side Bumpers
Parts needed for this procedure:
1
Left bumper
1
Right bumper
2
Carriage bolt (3/8 x 1-1/4 inches)
6
Flange nut (large flange–3/8 inch)
Procedure
1.
Remove the nuts and bolts holding the side
bumpers to the machine
Note:
Discard all nuts and only the 1 bolt
removed from each side
Note:
For 60- and 72-inch mowers, do not
install the bolt and flange nut for the left bumper
near the ROPS. You will install them when
you install the handle bracket in a following
procedure.
2.
Install the new left and right bumpers with 2
carriage bolts (3/8 x 1-1/4 inches), 4 previously
removed carriage bolts, and 6 flange nuts (3/8
inch) as shown in
1. Flange nut (large
flange–3/8 inch)
2. Right bumper
3. Use existing bolts
10
(Figure
5).
Figure
5.
Figure 5
4. Left bumper
5. Bolt (3/8 x 1-1/4 inches)
g009214
Advertisement
Table of Contents
