Top Cover Replacement; Remove The Top Cover - Lenovo HR650X V2 User Manual

• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1. Touch the static-protective package that contains the drive to any unpainted surface on the outside
of the server. Then, take the drive out of the package and place it on a static-protective surface.
Step 2. Install the drive in the drive bay.
a. Ensure that the drive tray handle is in the open position. Slide the drive into the drive bay until it
snaps into position.
b. Close the drive tray handle to lock the drive in place.
Figure 8. 2.5-inch hot-swap drive
Step 3. Check the drive status LED to verify that the drive is operating correctly.
a. If the yellow drive status LED is lit continuously, that drive is faulty and must be replaced.
b. If the green drive activity LED is flashing, the drive is being accessed.
Step 4. Continue to install additional hot-swap drives if necessary.
After you finish
1. Reinstall the security bezel if you have removed it.
2. Use the BMC to configure the RAID if necessary.

Top cover replacement

Use this information to remove and install the top cover.

Remove the top cover

Use this information to remove the top cover.
About this task
S033
30
HR650X V2 User Guide
Figure 9. 3.5-inch hot-swap drive