Remove The Rear 3.5-Inch Drive Backplane - Lenovo HR650X V2 User Manual

Step 2. Remove the rear drive cage.
a. Twist and pull out the blue plungers.
b. Slide the drive cage towards the rear of the chassis to release it.
Figure 41. Removing the 4 x 3.5-inch reard rive cage
After you finish
Remove the backplane from the drive cage. See "Remove the rear 3.5-inch drive backplane" on page 65.

Remove the rear 3.5-inch drive backplane

Use this information to remove the rear 3.5-inch 4-bay drive backplane.
About this task
Attention:
• Read "Installation Guidelines" on page 25 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1. Remove the middle drive backplane.
a. Open the release latches in the direction as shown.
b. Rotate the backplane from the top to disengage it from the pins on the drive cage.
c. Carefully lift the backplane out of the drive cage.
.
Chapter 4 Hardware replacement procedures
65