Lenovo HR650X V2 User Manual page 140

Table 44. Server management details
Item
BMC Self Test Status
BMC Device ID
BMC Device Revision
BMC Firmware Revision
IPMI Version
IPMI BMC Interface
BMC Support
Wait For BMC
FRB-2 Timer
FRB-2 Timer Timeout
FRB-2 Timer Policy
OS Watchdog Timer
OS Wtd Timer Timeout
OS Wtd Timer Policy
Serial Mux
BMC Configured Power
Control Policy
Power Control Policy
System Event Log
View FRU Information
BMC Self Test Log
BMC Network Configuration
View System Event Log
132
HR650X V2 User Guide
Option
N/A
N/A
N/A
N/A
N/A
N/A
Disabled/Enabled
Disabled/Enabled
Disabled/Enabled
N/A
Do Nothing/Reset/Power Down/
Power Cycle
Disabled/Enabled
N/A
Do Nothing/Reset/Power Down/
Power Cycle
Disabled/Enabled
N/A
Unspecified/Power Restore/
Last Power State/Do not
PowerUp
N/A
N/A
N/A
N/A
N/A
Description
-
-
-
-
-
-
Enable/Disable interfaces to communicate with
BMC.
Wait For BMC responses to specified time out. In
PILOTII, BMC starts at the same time when BIOS
starts during AC power on. It takes around 30
seconds to BMC interfaces.
Enable or disable FRB-2 timer (POST timer).
Enter value between 1 to 30 minutes for FRB-2
timer expiration.
Configure how the system responds if the FRB-2
Timer expires. Not available if FRB-2 Timer is
disabled.
If enabled, start a BIOS timer which can only be
shut off by Intel Management Software after the OS
loads. Helps determine that the OS successfully
loaded or follows the OS Boot Watchdog Timer
policy.
Enter the value between 1 to 30 min for OS Boot
Watchdog Timer Expiration. Not available if OS
Boot Watchdog Timer is disabled.
Configure how the system responds if the OS Boot
Watchdog Timer expires. Not available if OS Boot
Watchdog Timer is disabled.
Press Enter to enable or disable Serial Mux
configuration.
-
Configure how the system responds if AC Power is
lost. Power Control Policy will take effect
immediately after it's saved.
Press Enter to change the SEL event log
configuration.
Press Enter to view FRU information.
Log the report returned by BMC self test command.
Configure BMC network parameters.
Press Enter to view the System Event Log Records.