Lenovo HR650X V2 User Manual page 114

2. Align the processor on the new carrier so that the triangular marks align; then, insert the
marked end of the processor into the carrier.
3. Hold the inserted end of the processor in place; then, pivot the unmarked end of the
carrier down and away from the processor.
4. Press the processor and secure the unmarked end under the clip on the carrier.
5. Carefully pivot the sides of the carrier down and away from the processor.
6. Press the processor and secure the sides under the clips on the carrier.
Note: To prevent the processor from falling out of the carrier, keep the processor-contact
side up and hold the processor-carrier assembly by the sides of the carrier.
Step 3. Apply thermal grease.
a. Carefully place the processor and carrier in the shipping tray with the processor-contact side
down. Make sure the triangular mark on the carrier is aligned with the triangular mark in the
shipping tray.
b. If there is any old thermal grease on the processor, gently wipe the top of the processor with
an alcohol cleaning pad.
Note: Make sure the alcohol has fully evaporated before applying new thermal grease.
c. Apply the thermal grease on the top of the processor with syringe by forming four uniformly
spaced dots, while each dot consists of about 0.1 ml of thermal grease.
Figure 70. Thermal grease application with processor in shipping tray
Step 4. Assemble the processor and heat sink.
106
HR650X V2 User Guide