Install The Ocp 3.0 Ethernet Adapter - Lenovo HR650X V2 User Manual

Step 1. Remove the OCP 3.0 Ethernet adapter.
Figure 51. OCP 3.0 Ethernet adapter removal
a. Loosen the thumbscrew that secures the card.
b. Pull out the OCP 3.0 Ethernet adapter.
After you finish
1. Remove the OCP label.
2. Install a new OCP 3.0 Ethernet adapter or a card filler.
3. If you are instructed to return the defective component, follow all packaging instructions and use any
packaging materials that are provided.

Install the OCP 3.0 Ethernet adapter

Use this information to install the OCP 3.0 Ethernet adapter.
About this task
CAUTION:
Power off the server and disconnect all power cords from their power sources before performing this
procedure.
Attention:
• Read "Installation Guidelines" on page 25 to ensure that you work safely.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Note: If there is an OCP 3.0 Ethernet adapter installed, when the system is powered off but still plugged in to
AC power, system fans will continue to spin at a much lower speed. This is the system design to provide
proper cooling for the OCP 3.0 Ethernet adapter.
78
HR650X V2 User Guide