Rear 2.5-Inch Drive Backplane And Drive Cage Replacement - Lenovo HR650X V2 User Manual

Note: Depending on the specific type, your backplane might look different from the illustration.
Figure 36. 3.5-inch drive backplane installation
a. Align the backplane with the chassis and lower it into the chassis. Then, put the backplane into
place with it leaning backward slightly.
b. Rotate the backplane to vertical position to ensure that the four hooks on the chassis pass
through the corresponding holes in the backplane. Then, slide the new backplane as shown
until it is secured into place.
Step 4. Connect the cables to the system board.
After you finish
1. Reinstall all the drives and fillers (if any) into the drive bays. See "Install a hot-swap drive" on page 29.
2. Complete the parts replacement. See "Complete the parts replacement" on page 113.

Rear 2.5-inch drive backplane and drive cage replacement

Use this information to remove and install rear 2.5-inch drive backplane and drive cage.
• "Remove the rear 2.5-inch drive cage" on page 60
• "Remove the rear 2.5-inch drive backplane" on page 61
• "Install the rear 2.5-inch drive backplane" on page 62
• "Install the rear 2.5-inch drive cage" on page 62
.
Chapter 4 Hardware replacement procedures
59