Top Cover Replacement - Lenovo ThinkSystem SD530 V3 User Manual

Hide thumbs Also See for ThinkSystem SD530 V3:

Table of Contents

• <userid>:<password> are the credentials used to access the BMC (Lenovo XClarity Controller

interface) of your server. The default user ID is USERID, and the default password is PASSW0RD

(zero, not an uppercase o).

• <ip_address> is the IP address of the BMC.

Enable UEFI Secure Boot

Optionally, you can enable UEFI Secure Boot.

There are two methods available to enable UEFI Secure Boot:

• From Lenovo XClarity Provisioning Manager

To enable UEFI Secure Boot from Lenovo XClarity Provisioning Manager:

1. Start the server and press the key specified in the on-screen instructions to display the Lenovo

XClarity Provisioning Manager interface. (For more information, see the "Startup" section in the LXPM

documentation compatible with your server at

2. If the power-on Administrator password is required, enter the password.

3. From the UEFI Setup page, click System Settings ➙ Security ➙ Secure Boot.

4. Enable Secure Boot and save the settings.

Note: If disabling UEFI secure boot is needed, select Disable in step 4.

• From Lenovo XClarity Essentials OneCLI

To enable UEFI Secure Boot from Lenovo XClarity Essentials OneCLI:

1. Download and install Lenovo XClarity Essentials OneCLI.

To download Lenovo XClarity Essentials OneCLI, go to the following site:

https://datacentersupport.lenovo.com/solutions/HT116433

2. Run the following command to enable Secure Boot:

OneCli.exe config set SecureBootConfiguration.SecureBootSetting Enabled --bmc <userid>:<password>@<ip_

address>

where:

– <userid>:<password> are the credentials used to access the BMC (Lenovo XClarity Controller

interface) of your server. The default user ID is USERID, and the default password is PASSW0RD

(zero, not an uppercase o)

– <ip_address> is the IP address of the BMC.

For more information about the Lenovo XClarity Essentials OneCLI

https://pubs.lenovo.com/lxce-onecli/onecli_r_set_command

Note: If disabling UEFI secure boot is needed, run the following command:

OneCli.exe config set SecureBootConfiguration.SecureBootSetting Disabled --bmc <userid>:<password>@<ip_

address>