After you finish
If you are instructed to return the defective component, follow all packaging instructions and use any
packaging materials that are provided.
Install the front 3.5-inch drive backplane
Use this information to install the front 3.5-inch drive backplane.
About this task
The server supports one of the following backplanes. The installation procedure for the backplanes are the
same.
• 3.5-inch SAS/SATA 12-bay backplane
• 3.5-inch SAS/SATA 8-bay backplane
• 3.5-inch Anybay 12-bay backplane
Attention:
• Read "Installation Guidelines" on page 25 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1.
Touch the static-protective package that contains the new backplane to any unpainted surface on
the outside of the server. Then, take the new backplane out of the package and place it on a static-
protective surface.
Step 2.
Connect the cables to the backplane.
Step 3.
Install the 3.5-inch drive backplane.
58
HR650X V2 User Guide