Table of Contents
Advertisement
5
RPL Series Permalube
Fig. 5.82
Coupling Joint Flange
1.
Use a suitable fi xture or method to immobilize the drive fl ange
end so the coupling joint end will not rotate.
2.
Use a socket to remove the nut from the coupling joint fl ange.
3.
Remove the coupling joint fl ange from the driveline.
Assembly
Drive Flange
1.
Ensure the snap ring grooves are clean and free of debris and
clean if necessary. If the groove has debris, the snap ring will
not seat correctly.
2.
Insert the bushing on the bottom of the joint. Figure 5.83.
BUSHING
Fig. 5.83
3.
Install the cross into the drive fl ange. Figure 5.84.
MM-96147 / Revised 03-21
Page 38
4011756a
Fig. 5.84
4.
Ensure the universal joint and the bushings being installed are
aligned before applying pressure. If the components are not
aligned, damage to the universal joint or bushings can result.
5.
DRIVE
FLANGE
Fig. 5.85
6.
4011757a
Fig. 5.86
Copyright Meritor, Inc., 2021
DRIVE
FLANGE
Install the bushing on top of the cross and drive fl ange.
CAUTION
Verify the universal joint is positioned straight in the press
and is not cocked. Ensure the universal joint and the bushings
being installed are aligned before applying pressure. Press
down on the top bearing to install it down into the yoke hole
and onto the cross. Figure 5.85.
BUSHING
Install a cylinder and continue pressing down until the bushing
is seated low enough to install the snap ring. Figure 5.86.
BUSHING
CROSS
4011758a
PRESS
CROSS
4011759a
CYLINDER
4011760a
(16579)
Printed in USA
Advertisement
Table of Contents
