Table of Contents
Advertisement
5
RPL Series Permalube
Method Using a Universal Joint Press
1.
Position a universal joint press (Tiger Tool number 10707).
Figure 5.33. Refer to the Service Notes page on the front
inside cover of this manual for information to obtain this tool.
Fig. 5.33
2.
Turn the screw on the tool CLOCKWISE until the round
bushing loosens.
3.
Turn the screw on the tool COUNTERCLOCKWISE until you can
remove the round bushing.
4.
Turn over the universal joint. Repeat the procedure for the
opposite side of the universal joint.
5.
Remove the universal joint from the yoke.
Method Using a Universal Joint Puller
1.
Position a universal joint puller (Tiger Tool number 10102).
Refer to the Service Notes page on the front inside cover of
this manual for information to obtain this tool. Figure 5.34.
Fig. 5.34
2.
Turn the screw on the tool CLOCKWISE until the round
bushing loosens.
3.
Turn the screw on the tool COUNTERCLOCKWISE and remove
the round bushing.
4.
Turn over the universal joint. Repeat the procedure for the
opposite side of the universal joint.
MM-96147 / Revised 03-21
Page 26
UNIVERSAL
JOINT
PRESS
TIGER TOOL
NUMBER
10707
4001892a
UNIVERSAL
JOINT
PULLER
TIGER TOOL
NUMBER
10102
BUSHING
4001893d
Copyright Meritor, Inc., 2021
5.
Remove the universal joint from the yoke.
Disassembly
Slip Yoke
1.
Use a brass or copper hammer and a drift to tap the shroud
off the slip seal. Figure 5.35.
Fig. 5.35
2.
Use a screwdriver to pry the seal out of the groove in the slip
yoke. Figure 5.36.
Fig. 5.36
3.
Mark the slip yoke and slip shaft sections to ensure that you
reassemble them into their original positions. Figure 5.37.
Fig. 5.37
4.
Pull the slip yoke and slip shaft sections apart. Figure 5.38.
HAMMER
DRIFT
4001819c
4001820c
4001821d
(16579)
Printed in USA
Advertisement
Table of Contents
