Table of Contents
Advertisement
9
155R Series Slip Drive Shaft Assembly
Fig. 9.9
3.
Use a brush to distribute lubricant on the splines. Figure 9.10.
Fig. 9.10
4.
Install the new seal onto the spline shaft neck. Ensure that the
small diameter side fi ts onto the splines fi rst. Figure 9.11.
MM-96147 / Revised 03-21
Page 56
4003525a
4003524a
Copyright Meritor, Inc., 2021
SMALL
DIAMETER
Fig. 9.11
5.
Align the slip yoke and spline shaft sections with the phasing
marks you made on these sections during disassembly.
Figure 9.12.
PHASING MARKS
Fig. 9.12
6.
Install the spline shaft into the slip yoke until the splines fully
engage. Figure 9.12.
7.
Snap the seal into the groove. Figure 9.13.
SEAL
Fig. 9.13
8.
Push together the driveline sections. Figure 9.14.
LARGE
DIAMETER
4001829d
4001831b
(16579)
Printed in USA
Advertisement
Table of Contents
