Table of Contents
Advertisement
14
Measuring and Recording Driveline Angles
Phasing Type Box
NOTE: The phasing type is not required for angle analysis of one-
piece driveline confi gurations.
Fill in the "Phasing Type" box on the data gathering worksheet.
Refer to Phasing Type 1, 2, 3 and 4 examples listed on the
worksheet. Figure 14.4.
Type 1
These yokes
PARALLEL –
are aligned
PARALLEL
Type 3
These yokes
PARALLEL –
are aligned
CROSSED
Fig. 14.4
If you are unsure of the vehicle's phasing type, use "1" in the box.
Figure 14.5.
Phasing Type
1
(Refer to the
reverse side.)
Maximum
Engine RPM
Transmission
Top Gear
Ratio
Rear
Suspension
Ride Height
Maximum
Engine HP
Clutch
Fig. 14.5
MM-96147 / Revised 03-21
Page 78
These yokes
are aligned
These yokes
are not aligned
Transmission
Angle
4001904a
Copyright Meritor, Inc., 2021
Type 2
These yokes
CROSSED –
are not aligned
PARALLEL
Type 4
These yokes
CROSSED –
are not aligned
CROSSED
These yokes
are aligned
These yokes
are not aligned
4004053a
(16579)
Printed in USA
Advertisement
Table of Contents
