Table of Contents
Advertisement
5
RPL Series Permalube
YOKE BEARING CUP INSTALLATION METHOD
Fig. 5.55
UNIVERSAL JOINT PRESS METHOD
Fig. 5.56
PRESS METHOD
YOKE BEARING CUP
INSTALLATION TOOL
TOOL NUMBER
J-42368-3
Fig. 5.57
CAUTION
You must fully seat the snap ring into the snap ring groove to
avoid damage to the driveline.
6.
Use snap ring pliers to install the snap ring into the snap ring
groove. Figure 5.58. Fully seat the snap ring.
MM-96147 / Revised 03-21
Page 32
YOKE
BEARING
CUP
INSTALLATION
TOOL
NUMBER
J-44516
4001888d
UNIVERSAL
JOINT
PRESS
TOOL
NUMBER
10707
4001889d
PRESS
4001887d
Copyright Meritor, Inc., 2021
Fig. 5.58
7.
Position the second bushing onto the trunnion by threading
the cross through the yoke bore as shown. Figure 5.59.
Fig. 5.59
8.
Use a press, yoke bearing cup installation tool (SPX Kent-
Moore tool number J-44516) or universal joint press (Tiger
Tool number 10707) to install the second round bushing
slightly past the snap ring groove. Check that the bushing is
aligned with the universal joint. Figure 5.55, Figure 5.56 and
Figure 5.57.
CAUTION
You must fully seat the snap ring into the snap ring groove to
avoid damage to the driveline.
9.
Use snap ring pliers to install the second snap ring into the
snap ring groove. Figure 5.60.
WING
BUSHING
4001815c
Thread the
trunnion
through the yoke
bore to pilot the
round bushing
into the yoke.
4001816c
(16579)
Printed in USA
Advertisement
Table of Contents
