Table of Contents
Advertisement
Fig. 5.29
3.
Repeat the previous steps on the other side of the yoke.
Round Bushing Removal
NOTE: Use only the specifi ed tools to remove the round bushings.
Do not use the SPX Kent-Moore yoke bearing cup installation tool
(number J-44516) to remove the round bushings. Damage to the
tool can result.
Use one of the following procedures to remove and install round
bushings.
• Press, bridge tool and bearing cup bushing receiver
• Universal joint press
• Universal joint puller
DANGER
Observe all warnings and cautions provided by the press
manufacturer to avoid damage to components and serious
personal injury.
Method Using a Press, Bridge Tool and Bearing Cup
Bushing Receiver
1.
Use a press, bridge tool and bearing cup bushing receiver.
Figure 5.30. Refer to the Service Notes page on the front
inside cover of this manual for information to obtain these
tools.
(16579)
Printed in USA
Fig. 5.30
4001811c
2.
Press DOWN until the fi rst round bushing loosens.
Figure 5.30. Remove the round bushing. Figure 5.31.
Fig. 5.31
3.
Rotate the shaft 180 degrees. Repeat the procedure for the
opposite side of the universal joint. Figure 5.32.
Fig. 5.32
4.
Remove the universal joint from the yoke.
Copyright Meritor, Inc., 2021
5
RPL Series Permalube
PRESS
BRIDGE
TOOL
BEARING CUP
BUSHING
RECEIVER
4017054a
4001813c
4001814c
MM-96147 / Revised 03-21
Page 25
Advertisement
Table of Contents
