Table of Contents
Advertisement
Fig. 5.38
5.
Remove the seal and shroud. Figure 5.39 and Figure 5.40.
SEAL
Fig. 5.39
SHROUD
Fig. 5.40
Assembly
Slip Yoke
1.
Use the grease packet supplied with the slip yoke to apply the
entire amount of grease into the slip yoke. Figure 5.41.
(16579)
Printed in USA
4001822e
Fig. 5.41
2.
4001823a
Fig. 5.42
3.
4001824a
Fig. 5.43
4.
Copyright Meritor, Inc., 2021
5
RPL Series Permalube
Use a brush to distribute lubricant on the splines. Figure 5.42.
Install the new shroud. Figure 5.43.
Install the new seal onto the spline shaft neck. Ensure that the
small diameter side fi ts onto the splines fi rst. Figure 5.44.
4001826b
4001827b
4001828a
MM-96147 / Revised 03-21
Page 27
Advertisement
Table of Contents
