Table of Contents
Advertisement
5
RPL Series Permalube
Fig. 5.71
HALF-ROUND
SLEEVES
INSTALLED ON
BOTTOM
TRUNNION
Fig. 5.72
8.
Install the drive fl ange assembly back into the bearing cup
receiver. Refer to Section 16 for a tool drawing. Figure 5.73.
PRESS
Fig. 5.73
9.
Install the press bridge tool on the ears of the drive fl ange and
use a press to press DOWN. Figure 5.74.
MM-96147 / Revised 03-21
Page 36
HALF-
ROUND
SLEEVE
4011729a
4011730a
BRIDGE
TOOL
HALF-ROUND
SLEEVES
4011731a
Copyright Meritor, Inc., 2021
Fig. 5.74
10. Remove the half-round sleeves from the trunnion and remove
the bushing/bearing assembly from the receiver.
11. Install the half-round sleeves on the radius of the top trunnion.
Figure 5.75.
HALF-
ROUND
SLEEVES
Fig. 5.75
12. Turn the drive fl ange assembly over (rotate it 180 degrees)
and lower it into the receiver.
13. Install the press bridge tool and press DOWN. Remove the
half-round sleeves from the trunnion and the bushing/bearing
assembly from the receiver. Figure 5.76 and Figure 5.77.
BRIDGE
TOOL
RECEIVER
Fig. 5.76
4011732a
LOOSENED
BUSHING
4011753a
4011754a
(16579)
Printed in USA
Advertisement
Table of Contents
