Table of Contents
Advertisement
BRIDGE
Fig. 9.3
2.
Press DOWN until the fi rst round bushing loosens. Figure 9.3.
Remove the round bushing. Figure 9.4.
Fig. 9.4
3.
Rotate the shaft 180 degrees. Repeat the procedure for the
opposite side of the universal joint. Figure 9.5.
Fig. 9.5
4.
Remove the universal joint from the yoke.
Disassembly
Standard Slip Confi guration
1.
Mark the slip yoke and slip shaft sections to ensure that you
reassemble them into their original positions. Figure 9.6.
(16579)
Printed in USA
PRESS
BEARING CUP
BUSHING
RECEIVER
4001812c
Copyright Meritor, Inc., 2021
9
155R Series Slip Drive Shaft Assembly
Fig. 9.6
2.
Pull the slip yoke and slip shaft sections apart. Figure 9.7.
Fig. 9.7
3.
Remove the seal from the slip shaft. Figure 9.8.
SEAL
Fig. 9.8
Assembly
Standard Slip Confi guration
1.
Remove the grease fi ttings from the slip yoke before you
assemble the slip yoke and spline shaft sections.
2.
Use the grease packet supplied with the slip yoke to apply the
entire amount of grease into the slip yoke. Figure 9.9.
4001823c
MM-96147 / Revised 03-21
Page 55
Advertisement
Table of Contents
