Table of Contents
Advertisement
Customer Name:
Phone:
(
)
OEM:
VIN: (Last 6 digits only)
Date:
Maximum
Engine RPM
Transmission
Top Gear
Ratio
Rear
Suspension
Ride Height
Maximum
Engine HP
Clutch
Model
Transmission
Model
Main
Driveline
Series
Axle Model
Ratio
Before you measure a component, go to the side of the vehicle and look at the driveline:
If the FRONT of the component is HIGHER than the REAR of the component, the dimension
will be positive (+).
If the FRONT of the component is LOWER than the REAR of the component, the dimension
will be negative (–).
Assumptions
1. Drivelines are in the same plane. The top view shows all drivelines in a straight line.
For drivelines outside of the same plane, measure the offsets of each joint to the frame. Measure joint center to joint center lengths of each
shaft. Fax this information to OnTrac's Customer Service Center at 248-435-5580 or call the Center at 866-OnTrac1 (668-7221) for assistance.
2. Drivelines are balanced according to Meritor's driveline specifications.
Fig. 18.4
(16579)
Printed in USA
Fax:
(
Model:
Unit:
DSM:
Transmission
1st Driveline
Angle
Angle
Driveline Length
(Center to Center)
I/A Driveline
Series
Copyright Meritor, Inc., 2021
)
Driveline Angle Analysis
Year:
Data Gathering Sheet
Rear Axle
Angle
Tire Size
Angle
Front
Angle
18
Appendix
One-Piece, Single
Rear
MM-96147 / Revised 03-21
Page 99
Advertisement
Table of Contents
