Table of Contents
Advertisement
Chapter 6
Voice over IP
6.2.1 Configuration
Hardware installation
Basic MGCP
configuration
84
Use a phone cable to:
1
Wire the SpeedTouch™ Phone port(s) to your phone(s).
2
Wire the SpeedTouch™ PSTN port to your telephone wall outlet or distributed
filter depending on your Service Provider's specific needs.
Proceed as follows:
1
Open the SpeedTouch™ web pages:
For more information, see
Pages" on page
2
Browse to Voice > MGCP.
3
The MGCP configuration page appears.
4
If the Call Agent is located:
On your local network, click LAN.
On the WAN, click the interface name of your WAN connection.
5
Enter the Device Name and Call Agent IP Address.
6
Click Apply.
7
If you are:
Not using the PSTN port, no additional configuration is needed.
Using the PSTN port, continue with
"5.1 Accessing the SpeedTouch™ Web
44.
" PSTN Configuration" on page
85.
E-DOC-CTC-20041126-0014 v3.0
Advertisement
Table of Contents
