Table of Contents
Advertisement
6.1.1 Configuration
Hardware installation
Basic SIP configuration
E-DOC-CTC-20041126-0014 v3.0
Use a phone cable to:
1
Wire the SpeedTouch™ Phone port(s) to your phone(s).
2
Wire the SpeedTouch™ PSTN port to your telephone wall outlet or distributed
filter depending on your Service Provider's specific needs.
This step is only required if you still want to make phone calls using
the PSTN.
Proceed as follows:
1
Open the SpeedTouch™ web pages.
For more information, see
Pages" on page
2
Browse to Voice > SIP Basic
3
The SIP Basic Settings page appears.
4
If the SIP proxy and registrar are located:
On your local network, click Primary LAN.
On the WAN, click the interface name of your WAN connection.
5
Under SIP Registrar Address, enter the IP address or domain name of your SIP
registrar server.
6
Under SIP Outbound Proxy, enter the IP address or domain name of your SIP
proxy server.
7
Under Registration Information, enter the registration information provided
by your SIP registrar.
8
Click Apply.
9
If you are:
Not using the PSTN port, no additional configuration is needed.
Using the PSTN port, continue with
"5.1 Accessing the SpeedTouch™ Web
44.
" PSTN Configuration" on page
Chapter 6
Voice over IP
80.
79
Advertisement
Table of Contents
