Table of Contents
Advertisement
Summary
E-DOC-CTC-20041126-0014 v3.0
Configure the DHCP settings of the SpeedTouch™. Following fields are
available
DHCP Server On:
Click this option if you want the SpeedTouch™ to assign IP addresses to
the devices connected to the SpeedTouch™ network. Following fields
will become available:
Start IP Address:
Enter the start point IP address for the pool of IP addresses used by
your DHCP server.
End IP Address:
Enter the end point IP address for the pool of IP addresses used by
your DHCP server.
Leased Time (default: 1 day):
Enter the time for which you want to assign the IP address.
Make sure that at least one of the LAN IP addresses has the same
!
subnet as these DHCP lease pool addresses.
DHCP Server Off:
Click this option if DHCP service is not needed on the LAN.
Enter all the necessary settings and click Next for next page.
At the end of the configuration procedure, the Quick Setup wizard summarizes your
settings:
If you want to:
Make changes to the listed configuration, click Back.
Apply your settings:
1
Click Finish to accept these settings.
2
The SpeedTouch™ will restart in order to apply your changes:
3
Wait for 2 minutes before restarting your browser.
Chapter 5
SpeedTouch™ Web Interface
51
Advertisement
Table of Contents
