Table of Contents
Advertisement
1 SpeedTouch™610 Installation
1.3 SpeedTouch™610 Configuration Setup
Internet connectivity
What you need from
your SP
SpeedTouch™
configuration options
10
As soon as the SpeedTouch™610 is installed as described in
Wiring" on page 8
the SpeedTouch™610 can be prepared for Internet connectivity.
The configuration of your SpeedTouch™610 can be done semi-automatically via the
SpeedTouch™ Setup configuration files (available on the SpeedTouch™ Setup
CD-ROM), or manually via its web pages.
This section exclusively describes how to configure the SpeedTouch™610 via the Setup
configuration files. For advanced configurations via the SpeedTouch™610 web pages,
check
"3 The SpeedTouch™610 Web Interface" on page
You must have a user account with an Internet Service Provider (ISP) for Internet
access. For this user account, it will provide you with:
•
A user name (logon ID).
•
A password.
Other information might be required, depending on the ISP's specific requirements.
The method for configuring the SpeedTouch™610 via the Setup configuration files
depends on the Operating System (OS) of your computer system.
In case your computer system runs:
•
A Microsoft Windows OS
The SpeedTouch™ Setup wizard, included on the SpeedTouch™ Setup CD-ROM,
will automatically guide you through the configuration of both the
SpeedTouch™610 and your PC for setting up the appropriate configuration.
Proceed with
"1.3.1 Configuration Setup for Microsoft Windows Operating
Systems" on page
11.
•
Another OS, e.g. Mac OS, Unix, Linux, etc.
The SpeedTouch™ Embedded
Touch™ web pages, will automatically guide you through the configuration of the
SpeedTouch™610.
If needed, additional configuration of your computer(s) must be done manually.
Proceed with
"1.3.2 Configuration Setup for other Operating Systems" on
page
17.
"1.2 SpeedTouch™610
27.
Easy Setup
wizard, accessible from the Speed-
E-SIT-CTC-20030306-0004 v2.0
Advertisement
Table of Contents
