Setup/Startup
Initial Setup
To help prevent serious injury from
pinching or cutting, keep clear of the
cutting blade and moving carriage parts.
1.
Turn engine off and perform Pressure
Relief Procedure, page 7.
2.
Check engine and air compressor oil
levels.
NOTE: Use ONLY SAE 10W-30 (summer) or
5W-30 (winter) engine oil. Use ONLY
synthetic air compressor oil for the
compressor.
3.
Fill fuel tank.
4.
Remove blade guard. See, Blade
Guard Removal and Installation, page
14
8
Connecting a LineDriver
It is recommended to use a LineDriver in
conjunction with the TapeLazer. To connect
the TapeLazer to a LineDriver, follow the
steps below.
1.
Install LineDriver coupler to TapeLazer
hitch ball.
2.
Latch coupler to locked position.
3.
Insert safety pin into latch.
3A8108A