Blade Replacement
To help prevent serious injury from
cutting, wear gloves when handling the
cutting blade.
1.
Perform pressure relief procedure, see
Pressure Relief Procedure, page 7.
2.
Using a 1/4 in. Allen wrench, remove bolt
holding blade in place from either side of
the TapeLazer.
3.
Gently pull blade to remove it.
NOTE: Blade may become stuck from rust or
debris. If blade is stuck, remove bolt on
opposite side of the unit and place new blade
against the old one. Using a hammer, gently
tap new blade into place, pushing the old
blade out the opposite side.
3A8108A
4.
Install new blade into place.
5.
Using a 1/4 in. Allen wrench, reinstall bolt
and washers holding blade in place.
Maintenance
41