9.
Feed tape through rollers as shown.
NOTE: When installing tape through the
lower rollers, it is helpful to tamp the tape to
the brake roller and feed it through by
manually turning the roller (about half of a
turn) until tape appears on the other side
between the brake roller and applicator roller.
Pull tape away from the brake roller and to
within one inch of the ground.
3A8108A
Setup/Startup
Roller Adjustment
To help prevent injury from cutting, install
the blade guard or remove blade prior to
adjusting rollers.
1.
Perform pressure relief procedure, see
Pressure Relief Procedure, page 7.
2.
Using a 1/4 in. Allen wrench, adjust the
tape collars on the guide roller to match
the width and position of the tape.
NOTE: It is recommended you either have
the blade guard in place or remove the blade
prior to removing the applicator roller. See
Blade Guard Removal and Installation,
page 14.
3.
Remove front bolts on both sides of the
carriage holding the pivot bar in place
with a 1/4 in. Allen wrench.
11