Setup/Startup
Carriage Adjustment
To help prevent serious injury from
pinching or cutting, keep clear of the
cutting blade and moving carriage parts.
Often it is desirable to adjust the carriage to
an offset position to accommodate curbs or
difficult areas along the road edge. To adjust
the carriage into an offset position, follow the
steps below:
1.
Using a 3/4 in. wrench, loosen the four
bolts connecting the carriage to the
frame of theTapeLazer.
16
2.
Slide carriage left or right to the desired
location.
NOTE: Have a second person push down on
the TapeLazer handlebars to relieve tension
on the bolts while you slide the carriage right
or left.
3.
Notches are set in the carriage and
frame at one inch intervals which match
the lines on rollers to help with
alignment. A larger center notch allows
for easy reorientation to the center
position.
4.
Tighten bolts.
3A8108A