Setup - Graco ULTRA 1000 Instructions-Parts List Manual

~~
SETUP
1.
Connect Hose end Gun (Refer to Fig 1.)
a. Remove the plastic cap plug from the filter
outlet nipple and screw the 50ft 115.2 m) main
fluid hose onto the nipple.
b. Connect the whip hose between the fluid
hose
c. Don't usa thread sealant, and don't install the
and the gun inlet connection.
spray tip yet1
WARMING
If you are supplying your own hoses and spray
gun, be sure they ere electrically grounded and
rated for at least 3wO
psi
1210
bar1 Working
to reduce the risk of serious bodily injury caused
Pressure,
and that the gun has a tip guard. This is
by static sparking and fluid injection or over-
pressurizing and rupturing the equipment.
b
2. Two Gun Hookup. (Refer to Fig 1.) Remove the
cap from the 112 npsm(f) nipple and attach an ac-
cessory hose and gun.
To avoid damaging the pressure control, which
may result in poor equipment performance and
component damage, follow these precautions:
1. Always use nylon spray hose of at least
50 ft (15.2 m) lona.
2. Never use e wire braid hose as it is too rigid
to act as a pulsation dampener.
3. Never install any shutoff device between
the filter and the main hose. See Fig 2.
4. Always use the main filter outlet for one-
gun operation. Never plug this outlet.
3. Fill Packing NutlWet-Cur, (See
Fia
2.)
Throat Seal Liquid (TSL), supplied.
Fill the packing nut/wet-cup 1/3 f i l l with Graco
4. Check Electrical Service
a. Be sure the electrical service is 120 V,
60 HzAC, 15 Amp (minimum) and that the
outlet you use is properly grounded.
b. Use an extension cord which has 3 wires of a
minimum 12 gauge size, and
a maximum of
sprayer performance.
150 ft
I 4 5
m) long. Longer lengths may affect
5. Plug
in
the Sprayer
a. Be
sure the ONlOFF switch is OFF. Refer to
Fig 3.
b. Plug the power supply cord into a grounded
electrical outlet that is at least 20
ft
(6 m) away
from the spray area to reduce the chehce of a
spark igniting the spray vapors.
c. Do not remove the third prong of the power
supply cord plug, which is the grounding
prong, and do not use an adapter.
6. Flush the
pump
to remove the lightweight oil
which was l e f t in to protect pump parts after fac-
tory testing.
a. Before using water-base paint, flush with
then a clean water flush.
mineral spirits followed by soapy water, and
SECONDARY HOSE
Fig
2
b. Before using oil-base paint, flush with mineral
spirits only.
c.
See
FLUSHING GUIDELINES on pege 12 for
flushing procedure.
7 . Prepare the paint according to the manufacturer's
a. Remove any skin that may have formed.
recommendations.
b. Stir the paint to dissolve pigments.
c. Strain the paint through a fine nylon mesh bag
ticles that could clog the filter or spray tip.
This
(available at most paint dealers) to remove par-
is probably the most important step toward
trouble-free spray painting.
307-785
9