Cut Delay - Graco TapeLazer HP Automatic Operation, Parts

Cut Delay

Cut Delay allows adjustment for correcting
discrepancies between the actual tape length
placed on the road versus the programmed
distance displayed. System mechanical
inefficiencies can make this necessary. The
factory default is pre-set for best results, but
adjustments might be required from time to
time.
3A8108A
If the skip line is longer or shorter than the
displayed value follow the steps below.
1. Negative Tape Cut Delay (-X) is used
when actual tape length is longer than
programmed length. Decreasing Tape
Cut Delay will reduce tape length.
2. Positive Tape Cut Delay (+X) is used
when actual tape length is shorter than
programmed length. Increasing Tape
Cut Delay will increase tape length.
Operation
33