Kodak 5500 User Reference page 45

Error Code Number And Message Required Action(s)
E262_Rr_Cal_Illu-
mination_Failure
E263_Calibration
Target_Too_Short
E264_Cal_Target
Front_Too_Dark
A-61075 March 1997
Operator Action
Press the Jog key to remove the Calibration Target
from the transport system. Press the Cal key and try
the calibration process again. If the error message
persists, verify that the rear optical path is free of
obstructions, and clean the Imaging Guides. Press
the Cal key and try the calibration process again. If
the error message is displayed again, replace both
the Front Lamp and the Rear Lamp, and press the
Cal key to initiate the calibration process once again.
If the error message persists, contact the system
administrator.
System Administrator Action
Verify correct operation. If the error message persists,
call service.
Operator Action
Press the Jog key to remove the Calibration Target
from the transport system. Press the Cal key and try
the calibration process again. If the error message is
displayed again, utilize a 12-inch long Calibration
Target, and press the Cal key to initiate the calibration
process again. If the error message persists, contact
the system administrator.
System Administrator Action
Verify correct operation and the use of an appropriate
Calibration Target. If the error message persists, call
service.
Operator Action
Press the Jog key to remove the Calibration Target
from the transport system. Press the Cal key and try
the calibration process again. If the error message is
displayed again, utilize an appropriate Calibration
Target, and press the Cal key to initiate the calibration
process again. If the error message persists, contact
the system administrator.
System Administrator Action
Verify correct operation and the use of an appropriate
Calibration Target. If the error message persists, call
service.
OM-27