Kodak 5500 User Reference page 24

Error Code Number And Message Required Action(s)
E104_Function
Not_Available
E106_Doc_Length
Monitor_Warning
OM-6
Operator Action
Press the C (clear/cancel) key to clear the error
message (optional), then press the F key and input a
valid function code (refer to the function code listing).
This error message is just a warning to the operator. If
the error message is displayed when the transport
system is not running and if the error message is
cleared by pressing the C (clear/cancel) key, normal
scanning can be performed. If the error message is
displayed while scanning, the displayed error
message can be ignored a and the present scanning
can be continued and the error message will be
cleared at the completion of scanning when the Stop
or End key is pressed. If the error message persists,
contact the system administrator.
System Administrator Action
Verify correct operation. If the error message persists,
call service.
Operator Action
If necessary, note the document that was longer or
shorter than the defined maximum and minimum
lengths and press the C (clear/cancel) key to clear the
error message (optional). This error message is just a
warning to the operator; if the displayed error
message is ignored the present scanning can be
continued and the error message will be cleared at
the completion of scanning when the Stop or End key
is pressed. If the error message persists, contact the
system administrator.
System Administrator Action
Verify correct operation. If the error message persists,
call service.
A-61075 March 1997