Kodak 5500 User Reference page 31

Error Code Number and Message Required Action(s)
E151_Buffer_Data
Transfer_To_Host
E152_Scanning_-
Try_Again
A-61075 March 1997
Operator Action
Press the C (clear/cancel) key to clear the message
(optional), then press the F key to again input function
code F65 Bar Code Test. If all the images have not
yet been read by the host, the error message will be
displayed again. If the F key is again pressed and
function code F65 Bar Code Test is input and the
error message is still displayed, it is possible that the
host is not reading the images from the Image Buffer.
If this is the case, the operator must contact the
system administrator. This error message is just a
warning to the operator; if the error message is
cleared by pressing the C (clear/cancel) key, normal
scanning can be performed. If the error message
persists, contact the system administrator.
System Administrator Action
If required, send the Read command from the host.
Verify correct operation. If the error message persists,
call service.
Operator Action
Press the C (clear/cancel) key to clear the message
(optional), ensure that documents are not being
transported through the transport system and input
the desired function code if it is valid while the
transport is running, or press the Stop key to stop the
transport, then input the desired function code.
NOTE: The End key can be used in place of the Stop
key but the scanner will be disabled from the
host; to continue scanning after pressing the
End key, the system administrator must
enable the scanner from the host.
This error message is just a warning to the operator; if
the displayed error message is ignored the present
scanning can be continued and the error message will
be cleared at the completion of scanning when the
Stop or End key is pressed. If the error message
persists, contact the system administrator.
System Administrator Action
If required, enable the scanner from the host. Verify
correct operation. If the error message persists, call
service.
OM-13