Dip Switch Setting On Fpg-Com4; Difference Of Dimensions - Panasonic FPS Series User Manual

Communication
Communication modes
Communication mode
MEWTOCOL-COM Master/Slave
Program controlled
PLC Link
Modbus RTU Master/Slave
NOTE
PLC Link is only available for COM port 1.

8.2.5.1 DIP Switch Setting on FPG-COM4

There are two DIP switches on the cassette which must be set for RS485 connections:
•
switch SW1-1 to set the terminating resistor on the first and on the last station
•
switch SW1-2 to set the baud rate
For RS485 connections (COM port 1), the baud rate must be set in the system registers and
with the DIP switch. (For RS232C connections, the baud rate is only set in the system
registers.) For PLC Link, the baud rate must be set to 115200bit/s.
1
2
OFF
Rear of cassette
8.2.5.2 Difference in Dimensions
The FPG-COM4 communication cassette is 5mm longer than the other communication
cassettes.
162
1:1 communication
Switch
SW1
O
SW1-1
N
ON
SW1-2
X
X
X
Function Switch position
OFF ON
Terminating
resistor
OFF ON
OFF ON
Baud rate
OFF ON
FPΣ User's Manual
1:N communication
X
X
*)
X
X
Setting
General station (initial
setting)
First and last station
19200bit/s
115200bit/s (initial
setting