Procedure For Tilting Up (Power Trim And Tilt Models); Procedure For Tilting Down - Yamaha XF375 Owner's Manual

Operation
ECM00993
NOTICE
 Before tilting the outboard motor, follow the proce-
dure under "Stopping engine" in this chapter. Never tilt
the outboard motor while the engine is running. Se-
vere damage from overheating can result.
 To prevent the cooling water passages from becoming
frozen when the ambient temperature is 5°C (41°F) or
below, tilt the outboard motor up after it has been
stopped 30 seconds or more.
EMU3550C

Procedure for tilting up (power trim and tilt models)

1. Place the control lever in neutral.
2. Press the power trim and tilt switch "
outboard motor has tilted up completely.
UP
UP
UP
47
N
ZMU05829
" (up) until the
ZMU05837
UP
ZMU07998
3. Set the tilt support lever to support the engine.
WARNING! After tilting the outboard motor, be sure
to support it with the tilt support knob or tilt support
lever. Otherwise the outboard motor could fall back
down suddenly if oil in the power trim and tilt unit or
in the power tilt unit loses pressure.
Do not use the tilt support lever or knob when traile-
ring the boat. The outboard motor could shake loose
from the tilt support and fall. If the motor cannot be
trailered in the normal running position, use an addi-
tional support device to secure it in the tilt position.
For more detailed information, see page 50.
1
1. Tilt support lever
4. Once the outboard motor is supported with the tilt sup-
port lever, press the power trim and tilt switch "
(down) to retract the trim rods. NOTICE: Make sure
that the trim rods retract completely during moor-
ing. This protects the rods from marine growth and
corrosion, which could damage the power trim and
tilt mechanism.
[ECM00254]
1
1. Trim rod
EMU42702

Procedure for tilting down

1. Push the power trim and tilt switch "
outboard motor is supported by the tilt rod and the tilt
support lever becomes free.
2. Release the tilt support lever.
NOTICE:
[EWM00263]
[ECM01642]
1
"
" (up) until the