Yamaha XF375 Owner's Manual page 28

Components
When constant speed is desired, tighten the adjuster to
maintain the desired throttle setting.
EMU35721
Engine selector switch
When all engines have started, you can select the desired
engine for operation by pushing the engine selector switch.
The engine selector switch works only when all the control
levers are in neutral.
1. Engine selector switch
EMU35775
Engine shut-off cord (lanyard) and clip
The clip must be attached to the engine shut-off switch for
the engine to run. The cord should be attached to a secure
place on the operator's clothing, or arm or leg. Should the
operator fall overboard or leave the helm, the cord will pull
out the clip, stopping ignition to the engine. This will prevent
the boat from running away under power.
EWM01791
WARNING
 Attach the engine shut-off cord to a secure place on
your clothing, or your arm or leg while operating.
 Do not attach the cord to clothing that could tear
loose. Do not route the cord where it could become
entangled, preventing it from functioning.
 Avoid accidentally pulling the cord during normal op-
eration. Loss of engine power means the loss of most
steering control. Also, without engine power, the boat
could slow rapidly. This could cause people and ob-
jects in the boat to be thrown forward.
TIP:
The engine cannot be started with the clip removed.
23
ZMU05819
1. Engine shut-off cord (lanyard)
1
1. Engine shut-off switch
2. Clip
3. Engine shut-off cord (lanyard)
EMU41553
Main switch
The main switch controls the ignition system; its operation is
described below.
 "
With the main switch in the "
circuits are off, and the key can be removed.
 "
With the main switch in the "
circuits are on, and the key cannot be removed. The engine
can be started by pressing the Start/Stop button.
 "
With the main switch in the "
er motor turns to start the engine. When the key is released,
it returns automatically to the "
1. Main switch
EMU42082
Start/Stop switch panel
The engine can be started or turned off by pressing the
Start/Stop button. For twin and triple type, it is possible to
start or turn off individual engine. The indicator for the corre-
sponding engine will come on.
 PORT: Port side engine
 CENTER: Center engine
1
1
2
3
" (off)
" (off) position, the electrical
" (on)
" (on) position, the electrical
" (start)
" (on) position.
ON
OFF
1
" (start) position, the start-
START