Adjusting Fader Torque; Power Supply Unit Status Indicators - Sony CCP-8000 Operation Manual

Adjusting Fader Torque

You can adjust faders without removing them from the
center control panel or operation modules.
Proceed as follows to adjust faders.
1
Pull the fader lever to an upright position between the
two holes on the fader cover.
2
Insert a hexagonal screwdriver or a hexagonal wrench
(2.5 mm sides) into one or both of the holes and rotate
to adjust the torque. (For a single fader, adjust the
right side hole only. For a split fader, adjust both the
left and right holes.)
Rotate clockwise:
Fader lever operation becomes firmer.
Rotate counterclockwise:
Fader lever operation becomes freer.
Single fader modules
MKS-8020 Standard Transition Module
MKS-8030 Key Frame Module
MKS-8032 DSK Fader Module
MKS-8027 Compact Transition Right Module
MKS-8028 Compact Transition Left Module
Split fader modules
MKS-8021 Simple Transition Right Module
MKS-8022 Simple Transition Left Module
Power Supply Unit Status
Indicators
The power supply unit status indicators show the status of
the power supply unit during operation and when the unit
is powered on. Whenever a power error is detected, it is
reflected immediately by the indicator.
Meaning of status indicator displays
Indicator Status Description
color
Green Lit Operating normally
Red LIt Power supply unit fan
fault
−
Not lit Power supply unit
fault
Adjusting Fader Torque / Power Supply Unit Status Indicators
Steps to take
−
Exchange the
fan unit
Exchange the
power supply
unit
22