Panasonic Elite Big PAC-i S-200PE3E5B Technical Data & Service Manual page 58

1
For the shield part of the shielded cable, twist the end out, crimp it with a round terminal, and connect it to
the functional earthing screw.
After crimping it with a round terminal, wrap it with insulating tape so there are no spaces and adjust it so
the shield part does not touch any live parts.
Be sure that the shield part of the shielded cable does not touch the terminal block or any live parts.
CAUTION
Failure to do so may lead to electric shock or fire.
How to connect wiring to the terminal
For stranded wires
(1) Cut the wire end with cutting pliers, then strip the insulation to expose
the stranded wire about 10 mm and tightly twist the wire ends.
(2) Using a Phillips head screwdriver, remove the terminal screw(s) on the
terminal board.
(3) Using a ring connector fastener or pliers, securely clamp each stripped
wire end with a ring pressure terminal.
Stranded wire
Ring pressure
terminal
Crimp the round terminal
Shield part
(4) Put the removed terminal screw through the ring pressure terminal and then
replace and tighten the terminal screw using a screwdriver.
Screw
Special washer
Ring pressure
terminal
Wire
Terminal board
1-11-8
Wrap it well with insulating tape so
there are no spaces.
Screw and Special
washer
Ring
pressure
terminal
Wire