Panasonic Elite Big PAC-i S-200PE3E5B Technical Data & Service Manual page 170

2-8-3. Automatic address setting using the remote controller
Auto Address Setting from the High-spec Wired Remote Controller (CZ-RTC5B)
(1) Keep pressing the
simultaneously for 4 or more seconds.
The "Maintenance func" screen appears on the LCD display.
(2) Press the
If you wish to see the next screen instantly, press the
2
or button.
Select "9. Auto address" on the LCD display and press the
button.
Maintenance func
9. Auto address
10. Set elec. consumption
11. Set touch key
12. Check touch key
Sel.
(3) The "Auto address" screen appears on the LCD display.
Change the "Code no." to "A1" by pressing the
button.
Auto address
Code no.
A1
Sel.
Auto Address Setting* from the Remote Controller (CZ-RTC4)
* Auto address setting in Cooling mode cannot be done from the remote controller.
NOTE
Selecting each refrigerant system individually for auto address setting
Auto address setting for each system
: Item code "A1"
(1) Press the remote controller timer time
the same time.
(Press and hold for 4 seconds or longer.)
(2) Next, press either the temperature setting
that the item code is "A1".)
(3) Use either the
address setting.
(4) Then press the
(Auto address setting for one refrigerant system begins.) (When auto
address setting for one system is completed, the system returns to
normal stopped status.)
<Approximately 4 – 5 minutes is required.>
(During auto address setting, "
controller.
This message disappears when auto address setting is completed.)
(5) Repeat the same steps to perform auto address setting for each
successive system.
, and
or button to see each menu.
20:30 (THU)
Page [ ] Confirm
20:30 (THU)
O/D unit no.
1
Next
button and
/
button to set the system No. to perform auto
button.
" is displayed on the remote
buttons
(4) Select the "O/D unit no." by pressing the
or button.
Select one of the "O/D unit no." for auto address by
pressing the
Approximately about 10 minutes are required.
When auto address setting is completed, the units
return to normal stopped status.
button at
button. (Check
(2)
2-10
20:30 (THU)
[ ]
START
CZ-RTC5B
or button.
CZ-RTC4
(1) (4)
or
(4)
(3)