Panasonic Elite Big PAC-i S-200PE3E5B Technical Data & Service Manual page 121

3 Select the "Unit no." by pressing the
button for changes.
4 Select the "Code no." by pressing the
button.
Change the "Code no." to "5D" by pressing the
button (or keeping it pressed).
5 Select the "Set data" by pressing the
button.
Select one of the "Set data" in "Table for DC Fan
Motor Tap Settings" by pressing the
button.
Then press the button.
6 Press the button.
The "Exit detailed settings and restart?" (Detailed setting-
end) screen appears on the LCD display.
Select "YES" and press the
If you wish to change the selected indoor unit, follow the
step 2.
or
or
or
or
or
button.
1-12-2-2-14
<Procedure of CZ-RTC4>
Stop the system before performing these steps.
1 Press and hold the
simultaneously for 4 seconds or longer.
2 If group control is in effect, press the
At this time, the fan at the indoor unit begins and select
the address (unit No.) of the indoor unit operating.
3 Designate the item code
Temperature Setting
4 Press the timer time
desired setting data.
* For item codes and setting data, see the "Table for DC
Fan Motor Tap Settings".
5 Press the button.
(The display stops blinking and remains lit, and setting is
completed.)
If you wish to change the selected indoor unit, follow the
step 2.
6 Press the button to return to normal remote
controller display.
°
3
°
A
6
(4) Setting the Flap Separately
1) The 4-air outlet flap can be adjusted separately during
operation. When not adjusted separately, all flaps
operate in the same manner.
Air discharge
port
(adjustment for up-down airflow direction)
, and buttons
button to set.
by adjusting the
/ buttons.
/ buttons to select the
4
2
4
2
5
1
Flap
1