Panasonic Elite Big PAC-i S-200PE3E5B Technical Data & Service Manual page 50

1
1-10-2. External Air Intake Volume & Resistance
Within Unit / Operation Noise Characteristics
• 4-Way Cassette (Type U2)
When an External Air Intake Flange (ø100) is in Use
External Air Intake Volume and Resistance and
Operation Noise Characteristics within the Unit
100
90
80
70
60
50
40
30
20
10
0
0 5
External Air Intake Volume (m
With the External Air Intake Flange Attached
Type U2
Duct (ø100) for Connecting
the External Air Intake Flange
• Calculate the operation noise when external air is being
fed by combining the noise when only external air is being
fed as shown in the graph for operation noise
characteristics and the operation noise of the unit as
stipulated in the catalogue.
• The operation noise conforms to JIS standards and
constitute measurements taken in an anechoic chamber
1.5 m directly beneath the indoor unit.
Under normal circumstances, the values shown here are
greater owing to the effects of surrounding noise and
reverberation when the unit is actually installed.
The amount of external air that is possible to feed
when it is fed directly into the unit (ø100)
Type
Permissible Air Intake
Volume (m³/h)
NOTE
The operation noise for models that use small units is lower,
so use values that are within the range shown in the above
table.
Using values that exceed these will result in noise when only
external air is fed being louder than the noise emitted from the
unit.
50
40
30
Operation Noise
20
10 15 18 20
(External Air Intake Only)
3
/h)
50 60 71 100 125
15 17 18
CAUTION
In a Case of External Air Intake
Using Air Intake Chamber (CZ-FDU3+CZ-ATU2)
External Air Intake Volume & Resistance Within Unit/
Operation Noise Characteristics
100
90
Resistance within the unit
80
70
60
50
40
30
20
10
0
-10
0 50
External Air Intake Volume (m /h)
With the External Air Intake Chamber Attached
Filter chamber
(CZ-FDU3)
• Calculate the operation noise when external air is being
fed by combining the noise when only external air is being
fed as shown in the diagram for operation noise
characteristics and the operation noise of the unit as
stipulated in the catalogue.
• The operation noise conforms to JIS standards and
constitute measurements taken in an anechoic chamber
1.5m directly below the indoor unit. Under normal
circumstances, the diagram shown above is greater owing
to the effects of surrounding noise and reverberation when
the unit is actually installed.
(CZ-FDU3+CZ-ATU2)
The amount of external air that is possible to feed
18 18
when external air intake chamber is in use
Permissible air intake
volume (m
* The operation noise for models that use small units is
lower, so use values that are within the range shown in
the above table. Using values that exceed these will
result in noise when only external air is fed being louder
than the noise emitted from the unit.
1-10-2
Use the following diagram along with
the section "1-10-1. Precautions
Regarding External Air Intake".
(External air intake only)
(High speed wind)
50
40
30
20
100 150 200 240
3
Kit for external air intake (for chamber)
Connection duct: diameter ø100
Type
50 60
180 190
/h)
3
.
Operation noise
(CZ-ATU2)
71 100 125
240 240 240