Panasonic Elite Big PAC-i S-200PE3E5B Technical Data & Service Manual page 304

Installation when setting Main/Sub for the remote controller and the receiver
 Using 1 indoor unit
Installation R e c e v i
example
1 2
After installation, according to the "Settings" section, set one to [Main] and the other to [Sub].
Setting the wired remote controller to [Main] is recommended.
Attention
 Multiple wireless/infrared remote controllers cannot be used simultaneously for a single indoor unit.
 Be careful not to connect cables to other terminals of indoor units (e.g. power source wiring terminal). Malfunction may occur.
 Do not bundle together with the power source wiring or store in the same metal tube. Operation error may occur.
 If noise is induced to the unit power supply, attach a noise filter.
* Wiring shown below is prohibited.
The remote controller and the receiver can be connected to any indoor unit for operation.
When 1 indoor unit is operated by 2 remote controllers:
* Either of the remote controllers can be set to main/sub.
Wireless Remote Controller Kit Wired Remote Controller
(Sold Separately)
Receiver
CN1
1 2
Indoor Unit
Use wiring of 0.5 mm
8
Use a total wire length of no more than 400 m.
r e S ( u ) b W i e r d R C ( M i a ) n
1 2
Terminals for
RC wiring
RC wiring
(field supply)
• No polarity
R1 R2
Indoor unit
Wired RC Receiver
1 2 1 2
RC wiring
R1 R2
Indoor unit
(Sold Separately)
* (Main) * (Sub)
1 2
Remote Controller Wiring
(Field Supply)
2 to 2 mm 2 for field supply.
 Using more than 1 indoor unit
R e c e v i r e S ( u ) b
1 2
RC wiring ( field supply)
• No polarity
R1 R2 R1 R2
Indoor unit Indoor unit
1 2
R1 R2 R1 R2
Indoor unit Indoor unit
Receiver
If a group of units are to be controlled by 2 remote controllers:
* Main/sub remote controllers will work regardless of which indoor
unit they are installed.
Wireless Remote
Controller Kit
CN1
1 2
1st Indoor
Unit
Use wiring of 0.5 mm
Make the total wire length when cross-wiring a group no
more than 200 m.
8-28
W i e r d R C
1 2
R1 R2 R1 R2
Indoor unit Indoor unit
Cross-wiring Remote controllers for Group
Control (Field Supply)
Wired
Remote Controller
* (Main)
* (Sub)
1 2
2nd Indoor 3rd Indoor
Unit Unit
2 to 2 mm 2 for field supply.
( M i a ) n
4th Indoor
Unit