Panasonic Elite Big PAC-i S-200PE3E5B Technical Data & Service Manual page 306

3. Wiring the Receiver
Wiring Diagram
How to Connect the Wires
• Connect the wires from the receiver to the terminals for RC wiring on the indoor unit. (No polarity)
4. Installing the Receiver
 The receiver can be installed only on the corner shown in
Fig. A. Consider the direction where the panel is attached
to the indoor unit.
1
Remove the air inlet grille
Indoor unit electric component box
2
Remove the corner cover
① Remove the screw fixing the corner cover.
② Place a hand on both the right and left convex parts of
the corner cover to remove it.
Ceiling panel
Corner cover
8
Sec8.indd 17 SM830256-00_Single_欧州小筺体 TD&SM.indb
Indoor unit
Terminals for RC
wiring
Installation position for receiver (Fig. A)
Indoor unit electric component box
Air Inlet grille
Corner cover
Convex part
Screw
Convex part
Corner cover
17
Receiver PCB
CN001
R1
2P white
R2
3
Wire the receiver
① Hang the string of the receiver on the pin of the ceiling panel.
String
② Pass the wiring from the wireless receiver section into the slit.
(See "Wiring for the receiver")
③ Fix the wiring with the clamper (supplied) while leaving enough
length of wiring to remove the receiver.
• When attaching the filter chamber, cut the clamper (a), and
attach the receiver.
(a) Cut this clamper.
4
Fix the receiver
① Fit the receiver to the ceiling panel so the 5 claws are properly
set, and fix it with the removed screw.
• Make sure the wire is not caught.
• Refer to the installation instructions
supplied with the panel.
8-30
Pin Receiver
Slit
Fix with the clamper (supplied).
2012/02/28 16:14:02 16/12/28 13:40:3