Working With The Base Io Control Screen; Changing The Dome Address - American Dynamics SpeedDome Ultra 8 Operator's Manual

Working With the Base IO Control Screen

(Outdoor domes only) When Base IO Control is selected from the Dome Information
screen, the following screen is displayed and shows the base IO firmware version, enables
firmware updates, and controls the camera dome blower and heater
When you are finished working with the base IO controls, select Exit to return to the Dome
Information screen.

Changing the Dome Address

When a dome powers up, it finds Pan/Tilt home, determines the network type, and sequentially
performs the following three tests:
1. The dome checks to see if its own address has changed. If its own address changed since
the last time it was powered up, the dome local configuration memory is cleared.
2. Next, the dome checks to see if its address matches the IO base address.
•
•
SPEEDDOME ULTRA 8 CONFIGURATION UTILITY
OPERATOR'S GUIDE
Note: This feature is only applicable to the Outdoor Housing IO board: P/N
0311-0124-xx.
Figure 84. Base IO Control screen
Update App:
Blower Control: AUTO ON
Heater Control: AUTO OFF
If the dome address does not match the address currently stored in the IO base, the
Dome Address Changed screen (Figure 85) appears and allows you to update the
dome data from the IO board base memory or to clear the IO base memory.
If the dome address matches the IO base address, the dome performs the next
verification step.
BASE IO CONTROL
v2.30 => v2.30
EXIT
94 of 140
8200-0600-01, REV. B